HYDROXY TECHNOLOGIES - 1/4'' ID Auto-Sealing SS Washers (pack of 10)

1/4" Stainless Steel Bonded Sealing Washer. Seals and allows for material expansion under heat.s  Material: Stainless Steel  Outer Diameter: 0.625"
Type: Bonded Sealing Washer   Nominal Size: 1/4"                            website

HYDROXY TECHNOLOGIES - Brass Hose Barb,
1/4" x 1/4" MPT

This Brass Hose Barb is one of many top quality items in our Booster AddOns.

website

HYDROXY TECHNOLOGIES - Brass Hose Barb,
3/8" x 1/4" MPT

This Brass Hose Barb is one of many top quality items in our Booster AddOns.

website

HYDROXY TECHNOLOGIES - HHO Flashback Arrestor

1/4" Barb Fittings - Solid Brass Backfire Arrestor with stainless-steel screens. Tested to withstand engine's high-temperature and a flow-rate of up to 3 liter/minute. Suitable for vacuum or Air/Mainfold intake.

website

HYDROXY TECHNOLOGIES - 1/4" ID Hose x 6'
with clamps

1/4" ID High Temperature hose (fuel-line) x 6'. Suitable for connecting the Alexis Cell with Bubbler and Bubbler with engine intake. Includes 4 Stainless Steel 1/4" clamps.                                                                                                                       website

PROTIUM FUEL SYSTEMS - Auto Refill System

No Description Available

website

PROTIUM FUEL SYSTEMS - Fuel Systems Oxyisolator

The new "Protium Oxyisolator" now gives 'tuners' and 'hydrogen tinkers' a solution to false oxygen signals that trigger the CES (Check Engine Soon Light) and CEL (Check Engine Light).

website

PROTIUM FUEL SYSTEMS - Protium Fuel Heater

Our device uses the heat of your engine coolant system to pre-heat your fuel causing a more complete burn, increased horsepower by enhancing the effects of the Protium Gas Optimizer, higher gas mileage and improved carbon emissions.                                                             website

HYDRO FUEL SOLUTIONS - Special Socket fits O2 sensors
and O2 extenders

Special build Deep socket with slot for wiring to pass. Used for removal and installation O2 sensors and O2 extenders. fits a 3/8 ratchet Or a 7/8 wrench.

website

HYDRO FUEL SOLUTIONS - Special Offset O2
sensor wrench

Special built Off Set O2 sensor wrench for hard to reach areas Also fits our O2 extenders. Fis all 7/8 and 22 MM sensors Full wraparound design protects the sensor Slot to pass by the wiring so you Don't have to cut the wires!    website